Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 27)

Chapter 4: Using Your Washer
Product Service 1-800-522-7658 23
Loading Glassware into the FlaskScrubber
Glassware Holders are supplied with each FlaskScrubber. These holders enable
you to position glassware onto the FlaskScrubber spindles.
To use a Glassware Holder:
1.
Press the glassware into the holder; the clamps should spring out and grip the
glassware. Do not use with glassware over 2.5 inches in diameter as damage
to the holder may occur.
2.
The holder may be raised or lowered by squeezing the spring clip on the
bottom of the holder and then sliding the holder up or down.
3.
For best results, do not allow the glassware to rest directly on top of the
spindle.
Glassware should be loaded so that it does not touch during a wash cycle. The
washer has been designed for quiet operation. To prevent noise and glass
breakage, be certain that glassware is retained.
Note: It is normal for the clamps to deform if large glassware is inserted into the
Holder and the washer is operated at high temperature.