Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 36)

Chapter 4: Using Your Washer
Product Service 1-800-522-7658 32
32
11 = Drain After Wash 2
12 = Fill & Liquid Detergent Dispense
13 = Wash 3
15 = Drain After Wash 3
16 = Drain & Fill
18 = Fill Prior to Rinses – Includes Acid Rinse Dispense
Prior to First Rinse
19 = Final Rinse Delay
20 = Rinse
21 = Drain After Rinses
22 = Dry
23 = Cool
24 = Done
Columns 31-33 211 Raw data from temperature sensor #1
Columns 35-37 211 Raw data from temperature sensor #2
Columns 39-60 LW Shows alarms
LW = Low water level
LD = Low detergent
LR = Low neutralizing solution
LT = Low water temperature during Wash 2 or Last Rinse
OV = Water is detected in base
PW = Please wait
DF = Drain fail
There are several commercially available software packages, which can read RS-232
data and enter the data into a computer program such as a word processor (to create a
text file) or spreadsheet (to tabulate and plot the data). Consult your laboratory
supply catalog regarding the latest software available.
The following describes how to use an IBM compatible computer with Hyper
Terminal™ software (included with Windows® 95, 98, 2000,XP operating
systems) to collect the RS-232 data from your Washer.
1.
Make certain that the Washer is properly connected to the communication port
on the computer and that the communication port is enabled on the computer.
2.
Open Hyper Terminal™ software.
i) Windows® 95 or 98 use:
START/PROGRAMS/ACCESSORIES
ii) Windows® 2000 or XP use:
START/PROGRAMS/ACCESSORIES/COMMUNICATIONS
The first time Hyper Terminal™ is opened, a dialogue box requesting an area code and
phone number will appear. Enter the appropriate numbers and continue. This phone
number is required to proceed, but will never be dialed when the Washer is used.