Labconco FlaskScrubber Vantage Series Glassware Washers 4540031 - Manual (Page 31)

Chapter 4: Using Your Washer
Product Service 1-800-522-7658 27
Programming and Starting a Wash Cycle
Refer to Appendix C: Glassware Washer Specifications for complete details on
the various factory-set programs and the options available for customizing
programs. After you have decided which washer program to use, follow the
instructions below to start the washer.
Washers have the capability to wash glassware at high temperatures. Use care
when selecting high-heat programs if plasticware is being washed.
Any of the standard factory wash programs may be customized to suit specific
wash requirements. All changes made to the programs will be stored in the
washer microprocessor’s memory until it is changed again. If a FACTORY
RESET is performed, all inputs entered by the user will be erased and the
programs shipped with the washer will be reinstated. It is possible to customize
the following program parameters:
Wash 2 temperature
Wash 2 time
Wash 3 temperature
Wash 3 time
Total number of rinses
Number of purified water rinses
Final rinse temperature
Enable or disable the steam function
Dry temperature
Dry time
Liquid Detergent dispense
Rinse Aid dispense
Note: Wash 3 is available only if using the liquid dispense system rather than the
detergent dispenser in the door AND running programs INTENSE, INTENSE
PLUS, EXTREME, USER 1 or USER 2.
To program and start a wash cycle:
1.
Close the washer door and slide the latch to the right. This energizes the
electronic control and the display will show the last program that was run.
2.
Press RUN to select this program.
3.
If a different program is desired, press DISPLAY. The available programs
will be shown on the display.