Page 22, Equipment technical data, Safety instructions – Dexaplan DV 622 User Manual
Page 20
Page 22
Equipment
Technical data
Event recorder (see Fig. A)
1 event recorder
2 Button
: Cursor left / scroll
3 Button
/ “Motion Detection”: Cursor up / memory function on/off /
activate / deactivate
date and time
4 Button
: Cursor right / scroll
5 Button “Menu” (adjustment mode)
6 Button “Monitor” (channel selection)
7 Power LED
8 Video mode LED
9 Motion detection LED
10 Button “Play” (playback)
11 Button
/ “Quick Shot”: Delete / manual recording
12 Button
/ “Photo / AVI”: Cursor down / still image / AVI
13 Button “OK” for confirming
14 ON/OFF switch
15 Camera inputs CH1 / CH2
16 Video output
17 Power supply connection
18 Memory card slot for SD card
19 Power supply
20 Video output cable for connection to TV or video monitor
21 SCART adapter
22 Low voltage distribution cable
23 Camera including bracket
24 Connection cable
25 SD memory card
26 Wall plugs
27 Screws
Operating voltage:
5 V
DC
Power consumption:
max. 500 mA
Video inputs:
2 x Composite Signal (1.0 Vss ±10% at
75 Ohm)
Video output:
1 x Composite Signal
Resolution (pixels):
640 x 480 (still image mode)
320 x 240 (AVI mode)
Automatic recording:
max. 1 image /sec. (still image mode)
approx. 5 frames/second (AVI mode)
Memory requirement:
approx. 67 kB (still image mode) approx.
870 kB /10 seconds sequence (AVI mode)
Internal memory:
stores max. 20-30 still images or 2-3 video
sequences
Camera and accessories (see Fig. B)
Event recorder DVS 100
Storage capacity
2 GB SD card:
> 2,000 sequences (AVI mode)
Storage capacity
512 MB SD card:
> 500 sequences (AVI mode)
Factory setting:
channel 1
Dimensions (WxHxD):
approx. 208 x 47 x 134 mm
Weight:
approx. 300 g
Application:
only for indoor use
Operating voltage:
5 V DC ± 5%
Power consumption:
max. 100 mA
Resolution:
380 TV lines
Shutter:
automatic, electronic
Illumination:
Infrared LEDs (for illumination of the close
range during darkness)
Lens:
f = 6 mm, F = 2.0
Minimum illumination:
3 Lux (without LEDs)
Operating temperature:
-10 ° to +50 °C
Dimensions (WxHxD):
approx. 38 x 38 x 48 mm (without bracket
and cable)
Weight:
approx. 57 g (incl. bracket and cable)
Protection class:
IP44
Power supply:
100-240 V , 50/60 Hz, 0.2 A
Power output:
5 V DC, 1 A
Protection class:
II
Application:
only for indoor use
The following instructions are provided for your safety and satisfaction
during operation of the device. Note that non-observance of these safety
instructions results in significant risks of accident.
Do not leave small children unsupervised with the device, packaging
material or small parts. Otherwise there is a risk of fatal injury due to
choking or suffocation.
Do not damage any gas, electricity, water or telecommunication lines
during drilling and fixing work. Otherwise there are dangers of fire,
personal and fatal injury.
Treat the cables carefully. Lay these so that they cannot be damaged
and do not present any tripping hazard. Otherwise there are dangers
of fire, personal and fatal injury.
Camera C-80
Power supply DSA-5P-05 FEU or DSA-5P-05 FUK
Safety instructions
Danger!
!
!
!
> 25,000 images (still image mode) or
> 6,000 images (still image mode) or
If you use the device for monitoring babies or small children ensure
that the camera and cable are out of reach of children. Otherwise there
is a risk to life and limb!
Do not pull the cables over sharp edges and do not crush or crimp
!
!
GB / IE - 22