IDK MSD-804FD - Manual (Page 91)

MSD-804FD Users Guide (Command Guide)
91
@GEC Get control command (Control communication command)
Command
format @GEC, no
Return value
format @GEC, no, delay, port, memo, length, command, timeout, retry, interval, retryover,
display (
, recv_1, recv_2･･･)
Parameter no : Command number
1 to 32
delay :
0 to 999999
port : Output port
1 to 262143
bit6 bit5 bit4 bit3 bit2 bit1 bit0
Output
connector
LAN1
RS-232C
OUT4B
RS-232C
OUT3B
RS-232C
OUT2B
RS-232C
OUT１B
RS-232C
CH2
RS-232C
CH1
bit14 bit13 bit12 bit11 bit10 bit9 bit8 bit7
Output
connector
LAN
OUT1B*
LAN8 LAN7 LAN6 LAN5 LAN4 LAN3 LAN2
Specify “1” for the bit of the output port from which the command is sent (Since bit
23 to 19 are not used, always specify “0”). For example, if you send a command to
RS-232C CH1, specify “1”(0000000000000001 in binary). If sending a command to
LAN 1 and LAN 2, specify “192”(000000000000000011000000 in binary).
- bit18 bit17 bit16 bit15
Output
connector
-
LOOP
BACK
LAN
OUT4B
LAN
OUT3B
LAN
OUT2B
memo :
Up to 14 characters of 20 to 7D except 2C (,). “2 ASCII codes”
length : Data size of the send command (the number of bytes)
0 to 30
command : Send command data
Specify
length × 2 digits with 0 to 9, A to F, a to f = 4 bit per digit (in
hexadecimal)
timeout :
0 to 99999
retry :
0 to 99
interval : Interval between retries
0 to 99999
retryover : Processing at retry timeout
0 = Stop processing, 1 = Continue processing
display : Displaying received data
0 = Control communication command
recv_1-32 : Replied command check
1 to 32 = Reply command number to be checked is replied (separated with
commas).
Example Send
Receive
@GEC,1
@GEC,1,10,3,PO
WER,
7,5057204F4E0D0
Get the control command 1.
・
Delay: 10ms
・ Output port: RS-232C CH1 & RS-232C CH2
・ Memo: POWER