Lencore Spectra i.Net: Installation and Operations Manual - Manual (Page 25)

section 5
5.7 | installing power supply for other i.Net
®
ops
WARNING
NOTE: DO NOT PLUG IN UNTIL SYSTEM IS COMPLETELY WIRED AND CHECKED FOR
POLARITY. Irreversible system damage will result if polarity is not kept.
INSTALL THE POWER SUPPLY
Mount the power supply unit to the wall in a secure location as close to each i.Net OP as
possible. Use angle brackets and screws for mounting. Exception: 1st power supply in Lencore
branded enclosure for SmartSwitch and 1st i.Net OP.
Keep top fan and side vents exposed!
Take note of the three (3) positive and three (3) negative power terminals.
Do not plug in until system is completely wired and checked for polarity (see schematics on page 23).
2
3
4
1
21