NordicTrack ROUTER WITH VOICE 3G10WV - Manual (Page 47)

3G10WV HSPA Wi-Fi Router with Voice – 47
Enable DHCP
Server Relay
To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. To access
enable DHCP relay, please un-tick NAT enable first, that means to disable NAT
first, and then press save button. The Enable DHCP server Relay option will then
show up on the same page as below:
Enable Half-Bridge the HSPA 7.2 Mbps Wi-Fi Router can be set up as a half- transparent bridge to
cope with some special applications such as VPN pass-through. By default half-
bridge is off. Please refer to Appendix B for more information.
Enable NAT To enable/disable Network Address Translation (NAT, please refer to 7.2 for NAT
setting). By default NAT is enabled
Option 42, 66,150,160 These options are used for special DHCP set up
Static IP Lease List To specify the IP address assigned through DHCP according to the MAC address
of the hosts connected to HSPA 7.2 Mbps Wi-Fi Router
Enable DHCP Server
Relay
To relay DHCP requests from the subnet with no DHCP server on it to a DHCP
server on other subnets. DHCP Server Relay is disabled by default. To access
enable DHCP relay, please un-tick NAT enable first, that means to disable NAT
first, and then press save button. The Enable DHCP server Relay option will then
show up on the same page as below
Configure a second IP address by ticking the checkbox shown below and enter the following information:
IP Address: Enter the secondary IP address for the LAN interface.
Subnet Mask: Enter the secondary subnet mask for the LAN interface.
NOTE: The Save button saves new settings to allow continued configuration, while the Save/Reboot button not only saves new settings
but also reboots the device to apply the new configuration (i.e. all new settings).