Example 4 – NordicTrack ROUTER WITH VOICE 3G10WV User Manual

Page 93

Advertising
background image

3G10WV HSPA Wi-Fi Router with Voice – 9

config AP mode.
Default value : ap
--restrict <enabled|disabled>
config bridge restrict mode.
Default value : disabled

--rmac1 <MACaddress>
--rmac2 <MACaddress>
--rmac <MACaddress>
--rmac4 <MACaddress>

config remote bridge MAC address

NOTE 4:

You should enable the option - “restrict” before setting any restrict MAC address (setting --rmac1~4) or your

restrict MAC address setting will be ignored.
After the version – C40_R01, the wireless driver – .91.15.0 supports both BCM418 and BCM406; Version

- C9_R02 with the wireless driver - .61.1.0 supports only BCM406;
The behavior of wds is similar to connect two or more AP using a hub, be aware of the IP assignment to

prevent assigning two or more hosts / STAs to the same IP address. You could enable only one DHCP server in

one router and disable all other’s to avoid the conflict of the IP assignment.
WDS CLI does NOT support Enable(Scan) mode in Bridge Restrict while WEB does. If you set Bridge Restrict to

Enable(Scan) mode, the CLI will show Bridge Restrict disabled.

Example 4:

After example , we want to use wds to connect with the other AP which has disabled the DHCP server (NOTE

4) and has MAC address - 00:12:4:56:78:9a; we can achieve the goal using the following command.
wlan wds --mode wds --restrict enabled --rmac1 00:12:4:56:78:9a
info: Show the configurations of WLAN interface and the information of stations connected to this AP.
Options for the info command
wlan info [--config] [--security]

[--macfilter] [--wds] [--station]

--config

list parameters of config command

--security

list parameters of security command

Advertising