Yokogawa YFGW410 - Manual (Page 37)

<C3. Mounting>
C3-3
IM 01W02D01-01EN
C3.3 Installation of the YFGW410
1. Loosen the screws at both sides of the DIN rail mounting bracket (located on the rear panel
of the YFGW410), by rotating these screws in the reverse direction from the “Lock” position.
The screws do not drop even when fully loosened.
2. As shown in Figure C3-3, hook the top edge of the DIN rail mounting bracket onto the top of
the DIN rail, and return the YFGW410 back to the horizontal position. Then, hook the bottom
edge of the mounting bracket onto the bottom of the DIN rail.
3. Tighten the screws at both ends of the DIN rail mounting bracket, by rotating them toward
the “Lock” position. Tighten screws securely to ensure there is no clearance between the
bracket and the DIN rails.
4. Remove the YFGW410 by following the procedure described above in reverse.
After you have tightened the screws, loosen them by three turns.
FC0303.ai
Figure C3-3 Mounting of the YFGW410 on DIN rails