Yokogawa YFGW410 - Manual (Page 68)

<D3. Constructing a Field Wireless System>
D3-7
IM 01W02D01-01EN
At this tab, select the acquisition method for the IP address of the Field Wireless Backbone Net-
work in the YFGW410 and set the IP address and subnet mask settings.
With the default settings, the [Enable Automatic Backbone IP Address allocation] check box is
selected and the default settings shown below are automatically allocated.
To manually enter the [IP Address] and [Subnet Mask] settings, clear the [Enable Automatic
Backbone IP Address allocation] check box.
Item Description Default setting
Virtual IP Address
Virtual IP address of the Field Wireless Backbone Network
used to access from the Field Wireless Access Point
192.168.200.101
UNIT1 IP Address
The IP Address of the Field Wireless Backbone Network
of the YFGW410 connected to the UNIT1 connector of the
cable for redundancy.
192.168.200.103
UNIT2 IP Address
The IP Address of the Field Wireless Backbone Network
of the YFGW410 connected to the UNIT2 connector of the
cable for redundancy.
192.168.200.105
Subnet Mask Subnet mask of the Field Wireless Backbone Network 255.255.255.0
IMPORTANT
The following addresses are used internally by the YFGW410: UNIT1 IP Address +1 and UNIT2
IP Address +1. It is necessary to set IP Address settings such that there is no overlap with other
devices.
l Field Network1
When the YFGW410 is set for redundant operation and the [Field Network1] tab is selected, the
tab shown in Figure D3-5 appears at the main page.
FD0305.ai
Figure D3-5 Field Network1 Setting Tab (for Redundant Operation)