Yokogawa YFGW410 - Manual (Page 67)

<D3. Constructing a Field Wireless System>
D3-6
IM 01W02D01-01EN
When the YFGW410 is set for single operation and the [Field Network3] tab is selected, a win-
dow similar to Figure D3-3 appears.
The settings are the same as those for Field Network2. Configure the settings as necessary.
Default settings are shown below.
Item Description Default setting
Enable F3 Port Enable Field Network3
Check box cleared
(disabled)
IP Address IP address of Field Network3 192.168.2.101
Subnet Mask Subnet mask of Field Network3 255.255.255.0
n Network interface (when set for redundant operation)
When [Interfaces] is selected in the menu tree of the Configurator, the following four tabs are
displayed in the main window: [Field Wireless Backbone], [Field Network 1], [Field Network 2],
and [Field Network 3].
IMPORTANT
When the setting information of these tabs is edited, all backbone devices must be restarted
when the setting information is downloaded.
l Field Wireless Backbone
When the YFGW410 is set for redundant operation and the [Field Wireless Backbone] tab is
selected, the tab shown in Figure D3-4 appears in the main window.
FD0304.ai
Figure D3-4 Field Wireless Backbone Setting Tab (for Redundant Operation)