KROHNE OPTIFLEX 1300C EN - Manual (Page 66)

6
OPERATION
66
OPTIFLEX 1300 C
www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en
Information screens for a device with 1 output
Text and image
screen
Go to % current output
screen
Go to Text screen Go to
[    ] [    ]
Level [>>>>] <Output 1:
Output Function> 1
[>>>>] Level [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Interface Level 2 [>>>>] <Output 1:
Output Function> 1
[>>>>] Interface Level 2 [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Distance [>>>>] <Output 1:
Output Function> 1
[>>>>] Distance [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Interface Distance 2 [>>>>] <Output 1:
Output Function> 1
[>>>>] Interface Distance 2 [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Layer 2 [>>>>] <Output 1:
Output Function> 1
[>>>>] Layer 2 [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Volume (Mass) 3 [>>>>] <Output 1:
Output Function> 1
[>>>>] Volume (Mass) 3 [>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Interface Volume
(Interface Mass) 4
[>>>>] <Output 1:
Output Function> 1
[>>>>] Interface Volume
(Interface Mass) 4
[>>>>] (Text
and
image)
[    ] / [    ] [    ] / [    ]
Ullage Volume
(Ullage Mass) 3
[>>>>] <Output 1:
Output Function> 1
[>>>>] Ullage Volume
(Ullage Mass) 3
[    ] / [    ] [    ] / [    ]
Layer Volume
(Layer Mass) 4
[>>>>] <Output 1:
Output Function> 1
[>>>>] Layer Volume
(Layer Mass) 4
[    ] [    ] / [    ]
Back to the top of the
list
Signal screen 5
[    ]
Back to the top of the
list
1 Refer to the Operation: Function description section (Table C. Advanced setup, menu item C.3.1 Output Function)
2 This screen is for devices with the "interface" option only
3 This data is only available if you created a volume table (or a mass table). Refer to the Conversion menu in supervisor
mode (Quick Setup > Setup Mode > Conversion).
4 This screen is for devices with the "interface" option only. This data is only available if you created a volume table (or
a mass table). Refer to the Conversion menu in supervisor mode (Quick Setup > Setup Mode > Conversion).
5 This screen shows voltage amplitude of return signals against distance. It is used for finding level and interface when
there are interference signals. Push [>] to move the cursor from one signal peak to another.