Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 107)

TM
Model 3200 M0241-01
6/11 6-17
KPM II Monitor Operation
PROGRAMMING/CONNECTING SMM CONSOLE, SHAFT ROTATION SENSORS, SEED TUbES AND/OR RADAR/
MAGNETIC DISTANCE SENSORS
STEP 1 All sensors (including seed tubes w/sensors, radar, magnetic distance, SMM console and shaft rotation sensors) must be
unplugged from the harness and/or console and the monitor must be off.
NOTE: If the monitor detects a radar sensor but no seed tubes at power up, it automatically goes into AREA COUNT mode.
See “Area Counter/Speedometer Mode”.
NOTE: Disconnect magnetic distance sensor between MDS adapter and planter harness. DO NOT disconnect between MDS
and MDS adapter.
MDS Adapter
MDS
MDS Adapter
Harness
STEP 2 Press ON key. Monitor automatically enters setup procedure. Monitor scrolls “NO SENSOR” on top LCD of KPM II Stack-Mode
console.
STEP 3 The monitor automatically defaults to rear/front. Press SELECT key once for left/right and twice for four sections (front right/front
left/rear right/rear left). The selected display will be solid and configuration not currently selected will be flashing.
®
®
KPM II •