Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 130)

M0241-01 Model 3200
6-40 Rev. 7/12
TM
KPM III Monitor Operation
ENAbLING/DISAbLING INTERPLANT ROWS
To Enable or Disable Interplant
STEP 1 Return to “Planter Configuration” screen by pressing
F2 key next to “Plant”.
STEP 2 Press F6 key until “Kinze Planter Monitor III” screen
appears.
STEP 3 Turn rotary encoder knob or use arrow keys to
highlight ‘‘3. Disable Interplant (Enabled now)” or
Enable Interplant (Disabled now).
STEP 4 Press knob or Enter key to ‘‘Disable’’ or ‘‘Enable’’
Interplant. Row spacing is displayed on bottom of
screen to verify selection.
Press F6 to return to Plant screen.
Status
Plant
About
Kinze Planter Monitor III
Lifetime Area:
Please select the operating mode for the
planter monitor or the action to perform.
Effective row spacing: 15.0
0.00
1. Setup Mode
2. Acre Count Mode
3. Disable Interplant (Enabled now)
4. Data logging disabled
5. Test Mode
Status
Plant
About
Kinze Planter Monitor III
Lifetime Area:
Please select the operating mode for the
planter monitor or the action to perform.
Effective row spacing: 15.0
0.00
1. Setup Mode
2. Acre Count Mode
5. Test Mode
4. Data logging disabled
3. Enable Interplant (Disabled now)
Status
RowPop
Area
Other
Spacing
Avg
Pop
30618 8.03
1 2 3 4 5 6 7 8 9 10 11 12
1 2 3 4 5 6 7 8 9 10 11 12
120
110
100
90
80
70
60
%
120
110
100
90
80
70
60
%
AC1
TEST MODE
STEP 1 Press F6 key until Mode Selection screen appears.
STEP 2 Select ‘‘5. Test Mode’’ by turning rotary encoder
knob or using arrow keys. Press knob or Enter key
to display highlighted item.
STEP 3 Press F1 key next to Start.
STEP 4 “Test Mode Active” box displays showing number
of shaft revolutions. “End” box is highlighted. Press
knob or Enter key. “Test Mode Active” box displays
showing drill shaft revolutions.
Status
Plant
About
Kinze Planter Monitor III
Lifetime Area:
Please select the operating mode for the
planter monitor or the action to perform.
Effective row spacing: 15.0
0.00
1. Setup Mode
2. Acre Count Mode
3. Enable Interplant (Disabled now)
4. Stop Data Logging (Logging now)
5. Test Mode
Start
Help
Done
TEST MODE
Test mode report:
*** ***
Start
Help
Done
TEST MODE
Test mode report:
*** *** Test Mode Active...
Shaft revs:
End
0