Weiser SmartCode Lever - Manual (Page 7)

7
1 2
3 4
5 6
7 8
9 0
How the keypad works:
Each button represents two numbers (i.e. 1 and 2 for the first button). You
only need to push the button once to get either 1 or 2. For example: If
your code is 1-2-5-6-8,
■ Press the
1 2
button once to get number 1.
■ Press the
1 2
button once to get number 2.
■ Then press the
5 6
button once to get number 5.
■ Then press the
5 6
button once to get number 6.
■ Finally press the
7 8
button once to get number 8.
1 2
3 4
5 6
7 8
9 0
10. Programming a User Code.
● A programmed code can be from four (4) to eight (8) digits long.
● For maximum security an 8 digit code is recommended.
● Up to 4 user codes can be entered.
● Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (10a).
Note: Programming instructions can also be found on interior of lock.
a. Press the program button on the interior unit once.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
d.
a. Press the program button on the interior unit twice.
b. Enter in 4 to 8 digit code onto the keypad.
c. Press the “LOCK” button to save code.
d.
Press the “LOCK” button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Press the “LOCK” button and re-enter the code to test. Unit should go
to the unlocked position allowing exterior lever to retract the latch. If it
does not go to the unlock position, repeat steps (a) through (c).
Programming the 1st user code.
Programming the 2nd user code.
Program
Button
LOCK
Button
Continued