KEYENCE KV Series - Manual (Page 100)

Chapter 2 Editor
2-76
2
2.12.2 Error display
Compile ➔ Show Error (Ctrl + F10)
When an error occurs during compilation, a message is displayed and you can
confirm the contents of the error.
1. When an error occurs, the message "Compilation Error" is displayed.
2. Click the [OK] button.
The error list window is displayed.
3. To jump to the location in the program in which an error has occurred, specify the
desired error and click the [Jump] button.
The error location is displayed.
4. To display the error list again, select "Show Error" from the "Compile" menu, or
click the button.
2.12.3 Double coil check
Double coil check
Compile ➔ Check Double Coil
Double coil locations in a ladder program can be checked. (Double coil locations are
not detected as errors during compilation.)
Select "Check Double Coil" from the menu. Double coils are then detected.
Note: The double-coil check uses three instruction words: OUT, DIFU, and DIFD.
Even if double coil locations are not detected by the double coil check, they may
function as double coils depending on the assembly of ladder circuits.
Error code Contents
KVSKA Chap 02.P65 08.3.11, 11:29 AM 76