Interlogix Topaz User Manual - Manual (Page 266)

Topaz
User Manual
248
2. Wait for the Alarm Point configuration information to be displayed in the main window and the
Alarm Point description to be displayed in the “Description” window below the “Alarm Input
Points” window.
3. After making sure that the correct Alarm Point to delete is selected, click Delete.
4. A message “Are you sure you want to delete this record?” displays. Click OK to continue. A
message “Operation Complete” displays.
Alarm Point Options Page
The Options Page is used to assign digital cameras and video switchers to an alarm, to control
automatic masking actions and to link alarms to a relay. To navigate to the Alarm Point Options
page from any Hardware page click the Alarm Point tab button in the navigation bar at the top of the
main window and then the Options tab button. The following page displays.
Figure 175.Alarm Point: Options
The options page contains the following information:
DVMR Camera This is the DVMR camera that is linked to this alarm. Select the pre-configured camera from the
drop-down list. To configure a camera, click the Video | Camera tabs at the top of the screen and
complete the page that displays. For information about configuring a camera
How to add a new
video camera on page 262.
Video Switcher Alarm#
(Camera#) If an approved optional video switcher is connected to one of the serial ports of the server, the PC
can send a signal to the video switcher to trigger one of its alarms/cameras.
Enter the alarm/camera number of the optional video switcher that is to be activated when the
alarm point becomes active.
Note: When using a GE Video Switcher use the number of the camera to be called for the
Video Switcher Alarm # field.