Interlogix Topaz User Manual - Manual (Page 343)

Chapter 11
Color Graphics Maps
325
Note: When placing a new security area on the map the icon defaults to unmasked area icon even if the area is masked.
When the color graphics is back online, it checks for the current status of the area and change the icon
accordingly.
To delete or remove an icon from the map, click and drag the icon back to the tree window and
release the mouse button. The icon disappears and the red check mark on the icon in the tree is
removed.
Save your configuration changes by clicking the icon in the center of the toolbar the top of your
screen.
Color Coding Security Areas
The security area can be color coded and an outline of the area can be drawn in the same color.
When the area is masked, the outline of the area is filled with an overlay of mesh the same color as
set for the security area, as shown below.
Figure 220.Color coded security areas
To color code and outline the security area you must be in the configuration mode. After placing the
security area on the map double-click the security area icon you want to color code and the following
configuration window displays.