Comtech EF Data CDM-750 - Manual (Page 201)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Serial-based Remote Product Management MN-CDM750
7–21
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
Retrieve next
5 unread
Stored Events
N/A 80 bytes Query only.
Return the oldest 5 Stored Events which have not yet been read over the remote control in the form [CR]sub-
body[CR]sub-body[CR]sub-body[CR]sub-body[CR]sub-body, where Sub-body=ABCCddmmyyhhmmss:
A is fault/clear indicator where:
F=Fault
C = Clear
I = Info
B is the fault type where:
1 = Unit
2 = Rx Traffic
3 = Tx Traffic
4 = Info (Power on/off, or log cleared)
CC is Fault Code number, as in FLT? or Info Code, which may be:
0 = Power Off
1 = Power On
2 = Log Cleared
3 = Global Config Change
4 = Redundancy Config Change
ddmmyy = date stamp.
hhmmss = time stamp.
If there are less than five events to be retrieved, the remaining positions are padded with zeros. If there are no
new events, the response is RNE*.
N/A RNE? RNE=[CR]ABCCddm
myyhhmmss[CR]AB
CCddmmyyhhmmss[
CR]ABCCddmmyyhh
mmss[CR]ABCCddm
myyhhmmss[CR]AB
CCddmmyyhhmmss
(see description for
details of arguments)
Clear All
Stored Events
CAE= None Command only.
Forces the software to clear the events log.
Example: CAE=
CAE=
CAE?
CAE*
CAE#
N/A N/A
Initialize the
Stored Events
Pointer IEP= None Command only.
Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log. IEP=
IEP# N/A N/A
Management
IP Address
IPA= 18 bytes
numerical
Command or Query.
Set or return the IP Address and network prefix for the 10/100 Base-T Ethernet management port, in the format:
aaa.bbb.ccc.ddd.yy, where:
aaa = 000-223
bbb = 000-255
ccc = 000-255
ddd = 000-255
yy = network prefix (range: 8 to 31)
Example: IPA=010.006.030.001.24
IPA=
IPA?
IPA*
IPA#
IPA? IPA=xxx.xxx.xxx.xxx.
yy
(see Description of
Arguments)