H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 182)

166
Creating an IPv6 static route
1. Select Network > IPv6 Routing from the navigation tree.
2. Click the Create tab to enter the IPv6 static route configuration page, as shown in Figure 148 .
Figure 148 Creating an IPv6 static route
3. Specify relevant information as described in Table 69 .
4. Click Apply.
Table 69 Configuration items
Item Description
Destination IP Address
Enter the destination host or network IP address, in the X:X::X:X
format. The 128-bit destination IPv6 address is a hexadecimal
address with eight parts separated by colons (:). Each part is
represented by a 4-digit hexadecimal integer.
Prefix Length Enter the prefix length of the destination IPv6 address.
Preference
Set a preference value for the static route. The smaller the number, the
higher the preference.
For example, specifying the same preference for multiple static routes
to the same destination enables load sharing on the routes, while
specifying different priorities for them enables route backup.
Next Hop
Enter the next hop address, in the same format as the destination IP
address.