Calibration operations, Displaying channel status, Displaying neighbor information – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 383
367
Calibration operations
NOTE:
If RRM is not enabled, or the radio to be displayed works on a fixed channel, you can only view the work
channel and the power of the radio on the Operations tab in the Radio > Calibration page. Other
information such as interference observed and the number of neighbors is displayed when RRM is
enabled, that is, dynamic power selection or automatic dynamic frequency selection is enabled. For the
configuration of RRM parameters, see "
Displaying channel status
1.
Select Radio > Calibration from the navigation tree.
2.
On the Operations tab, click the Channel Status tab.
3.
Click the desired radio to enter the page for displaying channel status.
Figure 398 Channel status
Table 122 Configuration items
Item Description
Channel No
Running channel.
Neighbor Num
Number of neighbors on a channel.
Load (%)
Load detected on a channel.
Utilization (%)
Channel utilization.
Interference (%)
Interference detected on a channel.
Packet Error Rate (%)
Error rate for packets on a channel.
Retransmission Rate (%)
Retransmission rate on a channel.
Radar Detect
Radar detection status.
Displaying neighbor information
1.
Select Radio > Calibration from the navigation tree.
2.
On the Operations tab, click the Neighbor Info tab.
3.
Click the desired radio to enter the page for displaying neighbor information.