Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 364)

364 K2 Storage System Instruction Manual July 15, 2008
Chapter 8 Installing the Nearline 10 Storage System
For the NL10R system, if you have more Expansion chassis than those illustrated,
continue the indicated cabling pattern, alternating connections for additional
Expansion chassis between DP1 and DP0. Expansion chassis 1, 3, 5, 7, and 9 connect
to DP1. Expansion chassis 2, 4, 6, 8, and 10 connect to DP0.
Power on the Nearline 10 RAID chassis
Connect power cords and power up RAID storage devices as follows:
1. Verify power and cabling.
2. Press and hold down the power button on the controller, as shown.
If the RAID chassis has two controllers, you can press the power button on either
controller. You do not need to press both power buttons.
Pressing the power button on a controller also powers on any connected Expansion
FLT/LNK
FLT RDY
DP-OUT PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP 5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP
1 0
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP 5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP
1 0
Primary
Expansion 1
Expansion 2
DP0
To NH
server A To NH
server B To NH
server A To NH
server B To control port
on GigE switch A To control port
on GigE switch B
DP0
Controller 1 Controller 0
To
Expansion
3
To
Expansion
3
SAS cable connectors are keyed
to DP IN/OUT ports.
SAS cables
BBU IN MODEM
FLT/LNK
HPE FLT
A/L BACKUP
ACT/LNK LNK/ACT
FLT
HP 5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
BBU IN MODEM
FLT/LNK
HPE FLT
A/L BACKUP
ACT/LNK LNK/ACT
FLT
HP 5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
Power Cords
(115V/230V)
RDY
LED RDY
LED Power Good
LED
Power Good
LED