HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 503)

HEIDENHAIN iTNC 530 503
9.1
0
Specifying the positioning
beha
vior of the PLANE function
 Dist. tool tip – center of rot. (incremental): The TNC tilts the
tool (or table) relative to the tool tip. The SETUP parameter shifts the
center of rotation of the positioning movement relative to the
current position of the tool tip.
 Feed rate ? F=: Contour speed at which the tool should be
positioned.
1
1
1
1
Note:
„ If the tool is already at the given distance to the
workpiece before positioning, then relatively speaking
the tool is at the same position after positioning (see
figure at center right,
1 = SET UP).
„ If the tool is not at the given distance to the workpiece
before positioning, then relatively speaking the tool is
offset from the original position after positioning (see
figure at bottom right,
1 = SET UP).