HEIDENHAIN iTNC 530 (340 49x-04) ISO programming - Manual (Page 598)

598 12 Test Run and Program Run
12.6 Optional Bloc
k Skip
12.6 Optional Block Skip
Application
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
 To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
 To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
Erasing the “/” character
 In the Programming and Editing mode you select the block in which
the character is to be erased.
 Erase the “/” character.
This function does not work for G99 blocks.
After a power interruption the control returns to the most
recently selected setting.