Snmp – Epson AcuLaser CX37DNF User Manual
Page 175
SNMP
Item
Description
SNMP
SNMP
If Enable is selected, SNMP is enabled.
Choices: Enable, Disable
Default: Enable
Configuration Menu Equivalent:
UTILITY
- ADMIN. MANAGEMENT - NETWORK SETTING - SNMP
SNMP v1/v2c(IP)
If Enable is selected, SNMP v1/v2c(IP) is enabled.
Choices: Enable, Disable
Default: Enable
SNMP v3(IP)
If Enable is selected, SNMP v3(IP) is enabled.
Choices: Enable, Disable
Default: Enable
SNMP v1(IPX)
If Enable is selected, SNMP v1(IPX) is enabled.
Choices: Enable, Disable
Default: Enable
Note:
In order for this parameter to be available, NetWare Print in the Network -
NetWare page must be set to Enable.
UDP Port
Specifies the UDP port number.
Range: 1 - 65535
Default: 161
Note:
The numbers 427 and 500 cannot be specified.
SNMP v1/
v2c(IP)
Read Community
Name
Specifies the community name to be used for scanning.
Range: 1 to 15 bytes
Default: public
Write
If Enable is selected, Write is enabled.
Choices: Enable, Disable
Default: Enable
Write Community
Name
Specifies the community name to be used for reading and writing.
Range: 1 to 15 bytes
Default: private
Epson AcuLaser CX37 Series Reference Guide
Using Web-Based EpsonNet Config 175