RIGOL DSG3000 Series - Manual (Page 86)

RIGOL Chapter 2 Front Panel Operations
2-46 DSG3000 User’s Guide
Average Measurement
Average Mode
Press AVG MOD to select “Manul” or “Auto” average measurement mode.
 Manul: in this mode, you can set the “AVG NUM” of the measurement value
manually.
 Auto: the instrument configures the “AVG NUM” according to the measurement
value of the current signal automatically.
Average Number
Press AVG NUM to set the average number of the signal average measurement
manually. The range is from 1 to 1024.
Tips
1. When the “Auto” average mode is selected, the average mode will switch
to the “Manual” mode automatically after you set the average number via
AVG NUM.
2. Increasing the number of averages can reduce the measurement noise,
but will increase the measurement time.
Preset
Press Preset and the power meter parameters will be restored to the factory default
settings.
Limit Measurement
In limit measurement, the measurement is performed within the specified limit range.
If the measurement value exceeds this range, the measurement fails.
Measurement Type
Press Type to select the limit measurement type, including “Upper”, “Lower”, “Both”
or “Off”.
 Upper: select the maximum limit measurement. When the alert function is
turned on and the measurement value exceeds the maximum limit, the
instrument triggers the alarm.