Freescale Semiconductor Microcontrollers - Manual (Page 371)

HC08 P&E Multilink/Cyclone Pro Connection
Connection Procedure
371 Microcontrollers Debugger Manual
Pulse IRQ on Stop
The IRQ on Stop allows the users to execute a mechanism to stop a running HC08
microprocessor. For more information, refer to the Stop a Running HC908 Target.pdf
application note that is available from the P&E Microcomputer Systems website:
www.pemicro.com.
Target MCU Security Bytes
One of the steps that is necessary to properly bypass security is to provide the proper
security code for the information that is programmed into the part. This holds true even
when the part is blank. The security code consists of the 8 values, which are currently
stored in Flash locations $FFF6 - $FFFD of the processor.
Figure 14.11 P&E Connection Manager Window - P&E Multilink on LPT1 Interface
This window can be used to manually enter the proper security bytes via the USER
setting, or to load the security bytes from the same .S19 file which was programmed. The
bytes are loaded from a .S19 file by clicking the Load from S19 button.
IGNORE Security Failure and Enter Monitor
Mode
Use this checkbox to make the software ignore a failure so that it can properly pass the
M68HC08 security check. If the checkbox is set, the software attempts to establish