Freescale Semiconductor Microcontrollers - Manual (Page 497)

497 Microcontrollers Debugger Manual
22
SofTec HCS08 Connection
This chapter guides you through the first steps toward debugging with the CodeWarrior
IDE and the SofTec HCS08 connection. It does not replace all the additional
documentation provided in this manual, but gives you a good starting point.
SofTec HCS08 Technical Considerations
The 8/16 bit debugger (and then the CodeWarrior IDE) can be connected to HCS08
hardware using the SofTec HCS08.
When the debugger runs the SofTec HCS08 connection, it can communicate and debug
HCS08 core-based hardware connected through the SofTec in-circuit debugger/
programmer units, that is:
SofTec Microsystems HCS08 ISP Debuggers/Programmers (inDART Series) and Starter
Kits (PK and newer Series).
Refer to the inDART®-HCS08 In-Circuit Debugger/Programmer for Motorola HCS08
Family FLASH Devices User’s Manual from SofTec for communication hardware
requirements and SofTec product installation.
CodeWarrior IDE and SofTec HCS08
Connection
There are two separate paths that may be followed to take the first steps toward debugging
with the CodeWarrior IDE and the SofTec inDART-HCS08 connection. The differences
between the two paths hinge on the starting point for the steps:
• Using the Stationary Wizard at the start of the project
• From within an existing project