Freescale Semiconductor Microcontrollers - Manual (Page 499)

SofTec HCS08 Connection
First Steps from Within an Existing Project
499 Microcontrollers Debugger Manual
First Steps from Within an Existing Project
To take the first steps toward debugging with the CodeWarrior IDE and setting the SofTec
HCS08 connection from within an existing debugging project:
1. Run the CodeWarrior IDE with the shortcut created in the program group.
2. Open the project.
3. Choose Project > Debug to start the debugger.
4. In the debugger choose Component > Set Connection to select another target interface
in the Set Connection dialog box.
5. Select HCS08 as the Processor then SofTec HCS08 as the connection.
Figure 22.2 Set Connection Dialog Box - SofTec HCS08 Selection
6. Press the OK button - MCU Configuration dialog box opens.
7. In the MCU Configuration dialog box, choose the correct target processor.