Freescale Semiconductor Microcontrollers - Manual (Page 674)

ColdFire P&E Multilink/Cyclone Pro Connection
First Steps From Within an Existing Project
674 Microcontrollers Debugger Manual
Trigger Module Settings
Select MultilinkCyclonePro > Trigger Module Settings to open the Trigger Module
Settings dialog. Refer to the Debugger ColdFire On-chip DBG Module User Interface
manual for all related information.
Bus Trace
Select MultilinkCyclonePro > Bus Trace to open the Trace component window within the
debugger main window. Refer to the Debugger ColdFire On-chip DBG Module User
Interface manual for all related information.
Flash
Select MultilinkCyclonePro > Flash to open the Non-Volatile Memory Control dialog
box. For more information see
Flash Programming .
P&E Multilink/Cyclone Pro Setup Dialog
Box
In the communication tab, the communication protocol between the debugger and P&E
driver display can be activated. The protocol is displayed in the Command window. Use
this option only when requested by the Support team.
Figure 29.6 P&E Multilink/Cyclone Pro Setup Dialog Box - Communication Tab
In the communication tab, checking Disable maskable ISR’s when stepping option
provides a way to debug without diving in pending program ISR’s. When this option is
set, interrupts are masked before stepping as if changing directly the interrupt level in the
SR core register. When the step is performed, the interrupt level is reverted to previous
state, and if necessary, adjusted according to last executed instruction (when the stepped
instruction affects the interrupt level).