Freescale Semiconductor Microcontrollers - Manual (Page 669)

669 Microcontrollers Debugger Manual
29
ColdFire P&E Multilink/
Cyclone Pro Connection
This chapter guides you through the first steps toward debugging with the CodeWarrior™
IDE and the P&E Multilink/Cyclone Pro connection for ColdFire®. It does not replace all
the additional documentation provided in this manual, but gives you a good starting point.
P&E Multilink/Cyclone Pro Technical
Considerations
The 8/16/32 bits debugger (and then the CodeWarrior IDE) might be connected to
ColdFire hardware using the P&E Multilink Cyclone Pro connection.
When the debugger runs the P&E Multilink/Cyclone Pro connection, it can
communicate and debug ColdFire V1 core-based hardware connected through the P&E
BDM Multilink interface or through the P&E Cyclone Pro interface.
NOTE The BDM Multilink (parallel port) and USB-ML-12 Rev. A are no longer
supported in ColdFire V1.
CodeWarrior IDE and P&E Multilink/Cyclone
Pro Connection
There are two separate paths that may be followed to take the first steps toward debugging
with the CodeWarrior IDE and the P&E Multilink/Cyclone Pro connection. The
differences between the two paths hinge on the starting point for the steps:
• Using the Stationary Wizard at the start of the project
• From within an existing project