Sundance Spas ST201 User Manual
Page 52
52
Sundance Technology
ST201
PRELIMINARY draft 2
The loopback modes available to a host system when using the ST201 are shown in Table 3.
External loopback type is controlled by the Mll PHY device. The host system must enable a loopback mode
within MII PHY device using the MII Management Interface. For the true “on-the-wire” loopback mode, use
a loopback plug (connector), clear all of the loopback bits, set the FullDuplexEnable bit in the MACCtrl reg-
ister, and enable the full duplex mode within the MII PHY device.
30
Paused
This read-only status bit is set by ST201 to indicate that a PAUSE MAC
Control frame had been received and halted the transmit MAC for the
duration of the pause_time. It is cleared when the MAC can resume
transmission.
31
Reserved
Reserved for future use. Should be set to 0.
Loopback Mode
FIFOLoopback
MACLoopback
FullDuplexEnable
FIFO Loopback
1
0
x
MAC Loopback
0
1
x
External Loopback (MII) or
True “On-wire” External
0
0
1
TABLE 3: ST201 Loopback Modes
BIT
BIT NAME
BIT DESCRIPTION