Polycom ViewStation - Manual (Page 199)

Chapter 6 Troubleshooting
© Polycom, Inc. 183 ViewStation User Guide
ISDN Line errors when using
SPID configuration For ViewStation with BRI or DCP:
Go to the Numbers screen (System
Info > Admin Setup > Video
Network > Numbers) and check
the ISDN numbers are entered
correctly.
For ViewStation 128:
Go to the ISDN Video Network
screen (System Info > Admin
Setup > Video Network) and check
the ISDN numbers are entered
correctly.
Enter correct SPID numbers.
Note: The AT&T point-to-point
protocol does not require SPIDs.
Error Message occurs when
dialing a video call. The first line did not connect. It
cannot make a call if the first line
does not connect. Check that all network cables are
properly connected. Restart the
system.
If it is an H.323 call, IP Gateway/
Gatekeeper is not operating or is not
configured correctly. Contact your network administrator.
Symptom Cause Solution