Polycom KIRK KWS6000 - Manual (Page 101)

Configuring KIRK Wireless Server 6000
10–13
Configuring a KIRK Wireless Server 6000 Using DHCP
This section describes how to configure a KWS6000 using DHCP.
For information on accessing the web based Administration Page, refer to
“Accessing the Web Based Administration Page” on page 10-2.
This section contains information about:
•
“General Configuration” on page 10-13
• “Wireless Server Configuration” on page 10-14
• “Built-In Media Resource Configuration” on page 10-15
• “SIP Configuration” on page 10-15
• “Security Configuration” on page 10-15
General Configuration
Using DHCP the device request and obtain an available IP address from a
DHCP server. The device also obtain other parameters such as the default
gateway, subnet mask, DNS server, Time server and other IP parameters from
the DHCP server.
1
Click Configuration, and then click General.
Note
It is strongly recommended to configure the KWS6000 using a static IP
address.
Note
If the KWS6000 is configured using DHCP, it is necessary to assign a
reservation for the device on the DHCP server.