Polycom KIRK KWS6000 - Manual (Page 27)

Introduction to KIRK Wireless Server 6000
2–11
Installation Prerequisites
Before you start the installation you need to find the following information
and perform the following tasks:
• ARI codes (serial numbers) for the KWS6000 (see label on the rear of the
KWS unit)
• Serial numbers for handsets. Refer to “Retrieving the Serial Number of the
KIRK Handset” on page 8-10.
• AC codes (authentication codes)
The AC is a customer-defined optional subscription pin code of a
maximum of eight digits for the individual handset. The AC can be used
when connecting the handset to the KWS.
• Repeaters:
Mark each repeater with the number of the related base station. This way
you can easily configure the system on site.
• Handsets:
To use the handsets, you must first install the radio infrastructure, e.g.
base stations and repeaters to transmit and receive radio signals to and
from the handsets. There are no direct connections between the handset
and the system. For more information about base station and repeater
installation, refer to “Installing KIRK Base Station” on page 6-1 and
“Installing KIRK Repeater” on page 7-1.
• Charging battery
When charging the handset battery for the first time, leave the handset in
the charger for 14 - 16 hours to ensure that the battery is fully charged and
the handset ready for use. Refer to “Charging KIRK Handsets” on
page 8-6.
Note
Ensure that a site survey and deployment have been conducted and that the
installer has access to these plans before proceeding any further. For more
information about deployment, refer to “Deploying KIRK Wireless Server
6000”
on page 3-1
.