Polycom SOUNDPOINT 3804-11530-222 - Manual (Page 32)

Release Notes - SIP Application Changes
Page 26 Copyright © 2007 Polycom, Inc.
2.9.4 Configuration File Parameter Changes
The following configuration file changes have been included in this build in preparation for
future inclusion of the IP 650 platform in a software release. Support for the IP 650 is not
currently included in this release.
.cfg
File Action Parameter Description
sip added up.backlight.onIntensity This parameter controls the intensity of the
LCD backlight when it turns on during
normal use of the phone.
Possible values are 0, 1, 2 or 3.
0 = off
1 to 3 = low, medium, high
Null default is 3 (high).
sip added up.backlight.idleIntensity This parameter controls the intensity of the
LCD backlight when the phone is idle
Possible values are 0, 1, 2 or 3.
0 = off
1 to 3 = low, medium, high
Null default is 1 (low).
Note: If idleIntensity is set higher than
onIntensity, it will be replaced with the
onIntensity value.
sip added voice.codecPref.IP_650.G711Mu
voice.codecPref.IP_650.G711A
voice.codecPref.IP_650.G729AB
voice.codecPref.IP_650.G722
These parameters allow the voice codec
preference list to be set for the SoundPoint
IP 650 phone. By default the G.722 codec is
the first choice.
The use of these parameters is the same as
other voice.codecPref parameters.
sip added voice.audioProfile.G722.payloadSize
voice.audioProfile.G722.jitterBufferMin
voice.audioProfile.G722.jitterBufferMin
voice.audioProfile.G722.jitterBufferMin
These parameters configure the G.722
voice codec. The use of them is the same
as the other voice.audioProfile parameters.
sip added voice.gain.rx.analog.chassis.IP_650
voice.gain.rx.analog.ringer.IP_650
voice.gain.rx.digital.chassis.IP_650
voice.gain.rx.digital.ringer.IP_650
voice.gain.tx.analog.chassis.IP_650
voice.gain.tx.digital.chassis.IP_650
These parameters control gain settings
which are specific to the SoundPoint IP 650
phone. The values should not be modified.
sip added voice.rxEq.hs.IP_650.preFilter.enable
voice.rxEq.hs.IP_650.postFilter.enable
voice.rxEq.hd.IP_650.preFilter.enable
voice.rxEq.hd.IP_650.postFilter.enable
voice.rxEq.hf.IP_650.preFilter.enable
voice.rxEq.hf.IP_650.postFilter.enable
voice.txEq.hs.IP_650.preFilter.enable
voice.txEq.hs.IP_650.postFilter.enable
voice.txEq.hd.IP_650.preFilter.enable
voice.txEq.hd.IP_650.postFilter.enable
voice.txEq.hf.IP_650.preFilter.enable
voice.txEq.hf.IP_650.postFilter.enable
These parameters control equalization
settings which are specific to the
SoundPoint IP 650 phone. The values
should not be modified.