Polycom 6000 - Manual (Page 14)

User Guide for Polycom QDX 6000 Room System
8 © Polycom, Inc.
4. Press and hold a number to store the preset position. To store a
double-digit preset, press the first digit quickly and hold the second
number down. Any existing preset stored at the number you enter is
replaced.
The system uses preset 0 as the default camera position.
To delete all presets:
1. If you are in a call, press Near, and then choose a near-site video
source.
2. Press Preset on the remote control.
3. Press and hold Delete to delete all presets.
Switching Between Full-Screen Video and the Home Screen
When the call connects, the system automatically shows video on the whole
screen. You can switch back to the home screen during a call if, for example,
you need to adjust a user setting, and your system is configured to allow you
to do so.
To see video in the full screen:
 Press Near on the remote control.
To see the home screen:
 Press Home on the remote control.
Adjusting Screen Layout
In calls, you can change the current screen layout on the monitor. What you
see during a call can depend on factors such as the system monitor
configuration, the number of sites in the call, whether the Picture-in-Picture
(PIP) is enabled and whether the content is being shared.
To change the screen layout:
 In a call, repeatedly press PIP on the remote control to switch among
the screen layouts supported by the Polycom QDX 6000 system. These
might include the following layouts:
You cannot delete just one preset. Instead, overwrite an existing preset with the
new camera position.