Specifying, showing and turning off the pip – Polycom 6000 User Manual
Page 15
User Guide for Polycom QDX 6000 Room System
© Polycom, Inc.
9
Specifying, Showing and Turning Off the PIP
Your system can be configured to display a Picture-in-Picture (PIP) window if
your monitor is set to an aspect ratio of 4:3. You can show the PIP any time the
system is not sending or receiving content.
To specify whether and when to display the PIP:
1.
Select System from the Place a Call screen.
2.
Select User Settings from the System screen.
3.
Select
to see more settings
4.
Scroll to PIP, and select one of these settings:
1.
Far site, full screen
2.
Far and near sites, the same size, side by side
3.
Far site big, near site small (only available when
your monitor is configured to 16:9)
4.
Far site displayed in full screen, and near site in
the right-bottom small window (PIP layout, only
available when your monitor is configured to 4:3)
5.
Content displayed in the left big window, and far
and near sites in the right small window