Procedure a: emc legato networker – Quantum TC2201 User Manual
Page 149
Procedure A: EMC Legato NetWorker
Quantum TC2201 User’s Guide
129
Procedure A: EMC Legato NetWorker
1
1
Start the Windows Registry Editor program (as shown in
follows:
a
a. Select Start>Run.
b
b. Enter the following value in the Open text box: regedt32
c
c. Press [Enter].
%SystemRoot%\Winnt\System32\regedt32.exe
2
Select Window> HKEY_LOCAL_MACHINE> System>
CurrentControlSet> Services> QntmDLT
(or depending on
tape device being tested) to make that window active.
3
Select Edit>Add Key and enter Parameters for Key Name to create
a key named Parameters, if one does not exist.
4
To create a key named Device, open the Parameters key by selecting
Edit>Add Key
and enter Device for Key Name.
5
To create a DWORD named MaximumSGList, open the Device key
by selecting Edit>DWORD and entering MaximumSGList for
DWORD Name.
6
Open the MaximumSGList Value Name and replace the existing
Value Data in Decimal with a number at least as large as the block
size you need for the device.
To calculate the value, use the following equation:
(Block_Size / 4) + 1 = Value
•
64k 17 decimal 11 hex
•
96k 25 decimal 19 hex
•
128k 33 decimal 21 hex
•
256k 65 decimal 41 hex
•
512k 129 decimal 81 hex
Note:
You can also open this program at the following location:
Note:
Block Size Decimal Value Hex Value: