HP EVA P6000 Storage User Manual
Page 177
Advertising
Figure 90 Host details
Figure 91 Target tab
Issue: Windows initiators may display Reconnecting if NIC MTU changes after connection has
logged in.
Solution. Log out of those sessions and Log On again to re-establish the Connected state.
Issue: When communication between HP P6000 Command View and iSCSI or iSCSI/FCoE module
is down, use following options:
Solution 1. Refresh using Hardware > iSCSI Devices > iSCSI Controller 01 or 02 > Refresh button.
Solution 2. If the IPv4 management port IP address is set:
1.
Discover the controller. This option is exposed through iSCSI controller —> Set options
—> Discover controller
iSCSI module diagnostics and troubleshooting 177
Advertising