HP EVA P6000 Storage - Manual (Page 292)

Table 35 iSCSI or iSCSI/FCoE module log messages (continued)
FC2 processor POST failed. Fatal FC #%d: qlutm_init: Diagnostic
failed, port 2 POST failed
102422
FC processor failed to return diagnostic results. Fatal FC #%d: qlutm_init: Failed to
return diagnostic result to
Bridge
102423
FC processor failed reset. Fatal FC #%d: QLInitializeAdapter:
Reset ISP failed
102656
FC processor firmware load failed. Fatal FC #%d: QLInitializeAdapter:
Load RISC code failed
102657
FC processor receive sequencer code load failed. Fatal FC #%d: QLInitializeAdapter:
Load ISP2322 receive
sequencer code failed
102658
FC processor transmit sequencer code load failed. Fatal FC #%d: QLInitializeAdapter:
Load ISP2322 transmit
sequencer code failed
102659
FC processor firmware checksum failed. Fatal FC #%d: QLInitializeAdapter:
Verify Checksum command
failed (%x)
102662
FC processor firmware initialization failed. Fatal FC #%d: QLInitializeFW: FAILED 102680
FC processor paused due to internal parity error. Fatal FC #%d:
QLInterruptServiceRoutine:
102688
Risc pause %x with parity
error hccr %x, Disable
adapter
FC processor returned an invalid interrupt status. Fatal FC #%d:
QLInterruptServiceRoutine:
102689
Invalid interrupt status:
%x
FC processor system error. Fatal FC #%d: QLIsrEventHandler:
System error event (%x),
102716
MB1=%x, MB2=%x, MB3=%x,
MB4=%x, MB5=%x, MB6=%x,
MB7=%x
Response queue entry contains an invalid handle. Fatal FC #%d: QLProcessResponseQueue:
Invalid handle %x, type %x
102746
FC processor external SRAM parity error count
exceeded limit; FC port disabled. Fatal FC #%d: QLTimer: Ext Ram parity
error exceed limit cnt 0x%x,
limit 0x%x, Disabled adapter
102752
FC processor heartbeat failed. Fatal FC #%d: QLTimer: Heartbeat
failed
102755
FC processor being restarted.` Fatal FC #%d: QLRestartRisc: restart
RISC
102800
FC processor received a SCSI command for an
unknown target path or has run out of resources to
execute additional commands. Error FC #%d: QLUtmReceiveIo: Path
invalid/FW No resource count
%x
106583
FC processor was disabled by an IOCTL request to
the driver. Error FC #%d: QLIoctlEnable: Adapter
disabled
106589
FC processor firmware failed initialization. The
request to initialize was received by the driver in
an IOCTL request. Error FC #%d: QLIoctlEnable:
Initialize FW error
106590
292 iSCSI and iSCSI/FCoE module log messages