HP EVA P6000 Storage - Manual (Page 231)

Save
Saves logs and traces.
Admin session Authority
capture
logs
traces save Syntax
The save capture command creates a debug file that captures
all debug dump data. After the command completes, you must FTP
the debug capture file from the module. capture Keywords
The save logs command creates a tar file that contains the
module’s log data, storing the file in the module’s /var/ftp logs
directory. After the command completes, you must FTP the log’s tar
file from the module.
The save traces command creates a tar file that contains the
module’s dump data, storing the tar file in the module’s /var/ftp traces
directory. After the command completes, you must FTP the trace’s
tar file from the module. After executing this command, the system
notifies you if the module does not have any dump data. Each time
it generates dump data, the system adds an event log entry.
Example 1:
MEZ50 <1>(admin) #> save capture
Debug capture completed. Package is System_Capture.tar.gz
Please use FTP to extract the file out from the System.
Example 2:
MEZ50 <1>(admin) #> save logs
Save Event Logs completed. Package is System_Evl.tar.gz
Please use FTP to extract the file out from the System.
Example 3: Save traces is not supported by the iSCSI or iSCSI/FCoE modules.
MEZ50 (admin) #> save traces
Save ASIC Traces failed.
Set
Configures general iSCSI or iSCSI/FCoE parameters, as well as parameters that are specific to
the FC, iSCSI, and management ports.
iSCSI/FCoE module iSCSI module Command
alias
chap alias
chap Set
chassis fc [<PORT_NUM>]
fc [<PORT_NUM>] features
features iscsi [<PORT_NUM>]
iscsi [<PORT_NUM>] isns
isns mgmt
mgmt ntp
ntp properties
properties snmp [trap_destinations [<DEST_NUM>]]
system
snmp [trap_destinations [<DEST_NUM>]]
system
vpgroups [vpgroup index]
Commands 231