HP EVA P6000 Storage User Manual
Page 188
Table 27 Error Messages (continued)
How to correct
Meaning
Status code value
Correctly select the remote Continuous
Access group retry the request.
The remote Continuous Access group
specified does not exist.
95
Unknown remote DR group
Report the error to product support.
This error is no longer supported.
96
PLDMC failed
Retry the request later.
Another process has already taken the SCMI
lock on the storage system.
97
Storage system could not be
locked. System busy. Try
command again.
Resolve the condition and retry the
request
While the request was being performed, an
error occurred on the remote storage system.
98
Error on remote storage system.
Resolve the condition and retry the
request.
The request failed because the operation
cannot be performed on a Continuous
Access connection that is up.
99
The DR operation can only be
completed when the
source-destination connection is
down. If you are doing a
destination DR deletion, make
sure the connection link to the
source DR system is down or do
a failover operation to make this
system the source.
The storage system password may
have been re-configured or removed.
The management software is unable to log
into the device as the password has
changed.
100
Login required - password
changed.
The management software must be
used to set the password up to match
the device so communication can
proceed.
Log out of a management agent
session before attempting a new login.
The maximum number of login sessions
allowed to the storage system has been
reached.
101
Maximum logins
Retry the operation later. If the error
persists, report the error to product
support.
The command cookie sent in the attempted
command is invalid.
102
Invalid Cookie
Log in again.
The login session is no longer valid due to
timeout.
103
Login Timed Out
Remove a snapshot before attempting
this command again.
The virtual disk has reached the maximum
number of allowed snapshots.
104
Maximum Snapshot Depth
Case 1: Specify a valid capacity
value.
Case 1: Creation of the virtual disk failed
due to an invalid capacity value.
105
Attribute Mismatch
Case 2: Choose a valid mirror policy
value.
Case 2: Virtual disk mirror policy does not
match other snapshots.
Set a password before logging in.
Without a password no login is
required.
Management agent was not able to log in
because password is not set.
106
Password Not Set
Check if the port number refers to a
valid host port and try again.
Invalid port when trying to get host port
information.
107
Not Host Port
Unpresent the already presented
virtual disk or change the WWID of
this virtual disk.
A virtual disk with this WWID is already
presented.
108
Duplicate LUN WWID
Report the error to product support.
This error is no longer supported.
109
System Inoperative
Report the error to product support.
This is an internal error.
110
188 Error messages