Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 13)

Labconco Glassware Washer Service/Technical Manual
7
Removing the Washer Top, Back, and Side Panels
(Free-Standing models only)
To gain access to internal parts of the washer you will need to remove
the washer’s top, back, and side panels. This will make it possible
to clean, maintain, and repair the washer. Refer to the figure below
and follow the instructions to remove the top, back, and side panels
of your washer.
To Remove the Cosmetic paneling of the Washer
1. Turn off electrical power to the Glassware washer.
2. Remove all of the screws from the back panel of the washer and remove
the back panel.
3. Remove the 2 screws at the kick panel.
4. Remove the 2 screws at the rear that hold the sides to the top.
5. Remove the two screws from each side of the washer at the front edge.
6. Remove the side panels.
7. Remove the 2 screws that hold the top.
8. Remove the top