Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series User Manual
Page 7
Labconco Glassware Washer Service/Technical Manual
1
SECTION I:
Navigating the New Labconco Glassware Washers
This section will familiarize you with the functions needed to
perform various services on the washers. This includes running
diagnostic tests, and a general landscape of the interior of the
washer (pictures included).
Washer Menus
The latch serves as the on/off switch for the washer. When the latch is
closed (to the right) the machine will come on. The screen will Read
“LABCONCO Glassware Washer” and then a 7 digit number followed by a letter.
This number is the model/part number of the logic/PC Board, and the letter is
the revision of the programming logic.
The screen will then, automatically, return to the previous screen before the
unit was turned off. If the washer was in the middle of a cycle, it will
continue where it left off; however if the wash motor was running and the
unit was turned off and back on, there is a restart delay.
If the screen displays the name of a wash cycle, pressing DISPLAY will bring
you to the cycle select menu.
To program and start a wash cycle
1. Close the washer door and slide the latch to the right. This energizes the
electronic control and the display will show the last program that was
run.
2. Press RUN to select this program.
3. If a different program is desired, press DISPLAY. The available programs
will be shown on the display.
4. Press the ▲ or ▼ buttons until the desired program is indicated by the
arrow on the left side. The arrow on the lower right side means that there