Labconco SteamScrubbe & FlaskScrubbe Glassware Washers 44204 Series - Manual (Page 17)

Labconco Glassware Washer Service/Technical Manual
11
Adjusting the Door Latch Keeper Strike Plate
If, when the door is closed and latched, the latch is loose, or the
machine turns off during a cycle due to vibration or bumping, then you
may need to adjust the Door Latch Keeper/Strike Plate.
Adjusting the Door Latch Keeper/Strike Plate
1. Open the door to the glassware washer.
2. Loosen the two screws indicated by the Red Arrows.
3. To tighten the latching action of the Door Latch, move the plate in the
direction of the Blue Arrow.
4. To loosen the latching action of the Door Latch, move the plate in the
direction of the Yellow Arrow.
NOTE:
If this fails to correct the problem, perform electrical
troubleshooting on the Door Switch (located behind the plastic Control
Panel). The Door Switch Assembly may need to be replaced.
Replacing the Washer Light Bulb
If the Glassware washer is equipped with a window, you will need to
periodically replace the light bulb. Refer to the figure below and follow
the instructions to replace the washer light bulb.