5 info: frame, 6 info: interface, 7 info: mask – Mocomtech CDM-QX User Manual
Page 122: 8 info: ref, 9 info: id
CDM-Qx/QxL Multi-Channel Satellite Modem with DoubleTalk™ Carrier-in-Carrier®
Revision 7
Front Panel Operation
MN/CDMQX.IOM
5–56
5.7.5
INFO: Frame
This screen provides Framing and EDMAC Information. It shows the assigned EDMAC mode
and whether the unit is an EDMAC MASTER or SLAVE, along with the appropriate address.
Some examples are as follows:
Framing: AUPC-Only, D&I++
(ENT or CLR)
Framing:AUPC-Only,EDMAC2
(ENT or CLR)
Framing: AUPC+EDMAC2
Master,0240 (ENT or CLR)
Framing: AUPC+EDMAC
Slave, 0241 (ENT or CLR)
5.7.6
INFO: Interface
Interface: RS422 (ENT)
RTS/CTS Loop, No Action
This screen provides Interface Information; it shows details about the electrical interface type of
the main data port. Per the example shown, if RS422, V.35 or RS232 is selected, the screen will
also indicate the operation of RTS/CTS.
5.7.7
INFO: Mask
Mask: FIFO BPV TAIS RAIS
AGC EbNo BUF Ref
This screen provides Alarm Mask Information in the same format as the
CONFIG: MASK
menu
branch. It displays which alarms are currently masked. Per the example shown, iIf an alarm is not
masked, a blank is displayed in the relevant screen position.
5.7.8
INFO: Ref
Frequency Reference:
Internal 10 MHz (ENT)
This screen displays the source of the frequency reference for the CDM-Qx/QxL, as per the example
shown.
5.7.9
INFO: ID
Circuit ID: (ENT)
28 CHARACTER TST MESSAGE
This displays the user-defined Circuit ID string, which is entered via the UTILITY: ID menu
branch. Backup devices do not have an ID. Press
ENTER
to return to the previous menu.