Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 255)

Fabric OS Message Reference 233
53-1003140-01
CDR-1017
5
CDR-1017
Message
Blade in Slot <slot number> faulted due to unavailable ports in internal Trunk.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified blade is faulted due to unavailable ports in internal trunk.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
CDR-1018
Message
Blade in Slot <slot number> faulted due to Link reset threshold value exceeded.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified blade is faulted because the link reset threshold is exceeded.
Recommended
Action
When this error is observed persistently, power cycle the specified blade using the slotPowerOff and
slotPowerOn commands. If the problem persists, replace the blade.
CDR-1019
Message
S<slot number>,C<chip index>: HW ASIC Chip TXQ FID parity error threshold reached
type = 0x<chip error type>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that an internal error is observed in the application-specific integrated circuit (ASIC) hardware
that may degrade the data traffic.
Recommended
Action
Restart the system at the next maintenance window.