Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 708)

686 Fabric OS Message Reference
53-1003140-01
NS-1001
5
NS Messages
NS-1001
Message
The response for request 0x<CT command code> from remote switch 0x<Domain Id> is
larger than the max frame size the remote switch can support.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the response payload exceeds the maximum frame size the remote switch can handle.
Recommended
Action
Execute the firmwareDownload command to upgrade the remote switch with Fabric OS v4.3 or later, or
Fabric OS v3.2 or later, as appropriate for the switch type, so that it can support GMI to handle frame
fragmentation and reassembly.
You can also reduce the number of devices connected to the local switch.
NS-1002
Message
Remote switch 0x<Domain Id> has firmware revision lower than 2.2: <Firmware
Revision 1st character><Firmware Revision 2nd character><Firmware Revision 3rd
character><Firmware Revision 4th character> which is not supported.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the local switch cannot interact with the remote switch because of incompatible or obsolete
firmware.
Recommended
Action
Execute the firmwareDownload command to upgrade the remote switch to the latest level of firmware.
NS-1003
Message
Number of local devices <Current local device count>, exceeds the standby can
support <Local device count that standby can support>, can't send update.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Name Server on the standby control processor (CP) has a lower supported capability
than the active CP because of different firmware versions running on the active and standby CPs. This
means that the active and standby CPs are out of sync. Any execution of the haFailover or
firmwareDownload commands will be disruptive.