Brocade Fabric OS Message Reference (Supporting Fabric OS v7.3.0) - Manual (Page 823)

Fabric OS Message Reference 801
53-1003140-01
SEC-1300
5
SEC-1300
Message
This switch is in VcEncode mode. Security is not supported.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the switch is set up with VC-encoded mode.
Recommended
Action
Turn off VC-encoded mode before enabling security.
SEC-1301
Message
This switch is in interop mode. Security is not supported.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the switch is enabled in interop mode.
Recommended
Action
Disable interop mode using the interopMode command before enabling the Secure Fabric OS feature.
SEC-1302
Message
This switch does not have all the required PKI objects correctly installed.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates a corruption occurred during the distribution of the security database. This can only occur when
the primary fabric configuration server (FCS) distributes the security database to the other switches in
the fabric, and then local validation finds the error in the security database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in
the ready state. If a switch is in the error state, the database may not be correctly updated for that
specific switch.